Direct Bolt-On MAC True Fit designed of 100% aluminized steel construction, with proper heat shields where required, plus HTS coated, no welding or cutting needed. It is a True Fit bolt-on kit that comes with flange nuts, studs, and conveniently slips into stock hanger locations to provide an easy one-man installation. This kit comes with MAC’s Flow Path® mufflers welded directly into the system, and does not use clamps or need welding. MAC’s Big Flow Path® muffler is a multi passage design with out packing to burn out. That means, that sound control will be the same, mile after mile! Flow Path® mufflers flow more exhaust gases than most other makes while maintaining modest sound control levels. Flow Path® mufflers will flow as much volume as a 4 inch straight pipe, and do it quietly. This kit is designed for maximum power and easy installation, with a distinctive performance sound upon hard acceleration, and mellow tone while cruising. Up to 24 rear wheel horsepower, and a 4% increase in fuel economy. More torque for safer passing, towing, and pulling on hills.Note: All sizes of MAC Cat-Back Kits fit to Stock or any MAC Off-Road, Catalytic H-Pipes or Y-Pipes.
Installation Time: 30-50 Minutes
2-3" Inlet, 4" Tail
|
